Company Profile
Air Conditioning Systems
Heating Systems
Air Filters
Humidifiers
Thermostats
Zoned Systems
Preventative Maintenance
Maintenance Agreements
New Construction
Service Areas
Employment
Specials
Saving Energy
Client List


Saving Energy

A few simple steps can add up to
a load of savings.

Set your thermostat at 78°F or higher. Each degree setting below 78°F will increase your energy consumption by approximately 8%.

Use bath and kitchen fans sparingly when the air conditioner is operating.

Inspect and clean both the indoor and outdoor coils. The indoor coil in your air conditioner acts as a magnet for dust because it is constantly wetted during the cooling season. Dirt build-up on the indoor coil is the single most common cause of poor efficiency. The outdoor coil must also be checked periodically for dirt build-up and cleaned if necessary.

Check the refrigerant charge. The circulating fluid in your air conditioner is a special refrigerant gas that is put in when the system is installed. If the system is overcharged or undercharged with refrigerant, it will not work properly. You may need a service contractor to check the fluid and adjust it appropriately.

Reduce the cooling load by using cost-effective conservation measures. For example, effectively shade east and west windows. When possible, delay heat-generating activities, such as dishwashing, until the evening on hot days.

Over most of the cooling season, keep the house closed tight during the day. Don't let in unwanted heat and humidity. If practical, ventilate at night either naturally or with fans.

Try not to use a dehumidifier at the same time your air conditioner is operating. The dehumidifier will increase the cooling load and force the air conditioner to work harder.

NEXT


 


How Your A/C System Works


Care & System Maintenance













Copyright 2008, Air Pro Services. All rights reserved.